新聞資訊
斷續時效對2519A鋁合金組織和力學性能的影響
發布人：上海艾荔艾金屬材料有限公司www.85978597.cn
更新時間：2015-08-22
通過硬度試驗、拉伸試驗、掃描電鏡以及透射電鏡研究斷續時效對2519A鋁合金板材微觀組織和力學性能的影響。
斷續時效對2519A鋁合金組織和力學性能的影響Effects of interrupted ageing on microstructure and
mechanical properties of 2519A aluminum alloy
通過硬度試驗、拉伸試驗、掃描電鏡以及透射電鏡研究斷續時效對2519A鋁合金板材微觀組織和力學性能的影響。研究表明：2519A鋁合金經斷續時效(T9I6)后，其屈服強度、抗拉強度和伸長率分別為501
MPa、540 MPa和14%，相比于2519A-T87狀態鋁合金的450 MPa、480 MPa和9%，分別提高了51 MPa、60
MPa和5%。在斷續時效過程中，低溫保溫可以使基體內不斷形成大量臨界尺寸的密集、細小的GP區，而使時效相也趨于細小、密集，從而提高了合金的力學性能。
The effect of interrupted ageing on the microstructure
and mechanical properties of 2519A aluminum alloy was studied by means of
hardness, tensile test, SEM and TEM. After the T9I6 heat treatment, the yield
strength, tensile strength and elongation of 2519A aluminum alloy can reach 501
MPa, 540 MPa and 14%, respectively. Compared to T87 temper, which is 450 MPa,
480 MPa and 9%, respectively, the mechanical properties of 2519A-T9I6 increases
by 51 MPa, 60 MPa and 5%, respectively. During the process of interrupted aging,
keeping the alloy in a lower temperature contributes to forming the numerous,
finer and denser GP zone with critical size. So, the following precipitated
phase will also be finer and denser, which results in the increasing mechanical
properties of 2519A aluminum alloy.
以上資料由上海艾荔艾金屬材料有限公司提供，歡迎新老客戶來電洽購。
本文來自上海艾荔艾金屬材料有限公司http://www.85978597.cn，轉載請注明出處。