新聞資訊
AZ91D鎂合金等離子噴涂Ni-Al/陶瓷涂層的組織和性能
發布人：上海艾荔艾金屬材料有限公司www.85978597.cn
更新時間：2015-10-13
以Ni-Al為粘結層，在AZ91D鎂合金基體上等離子噴涂Ni-Al/Al2O3、Ni-Al/Al2O3-13%TiO2 (Ni-Al/AT13)、Ni-Al/Al2O3-20%TiO2(Ni-Al/AT20)復合涂層及Ni-Al/Al2O3/Al2O3-13%TiO2/Al2O3-20%TiO2 (Ni-Al/Al2O3/AT13/AT20) 梯度涂層，利用SEM、EDS和XRD分析涂層的微觀組織特征，通過硬度、拉伸和熱震實驗研究涂層硬度、結合強度和抗熱震性能，并與直接噴涂Al2O3、AT20的涂層進行比
AZ91D鎂合金等離子噴涂Ni-Al/陶瓷涂層的組織和性能Microstructure and properties of Ni/Al/ceramic coatings?plasma-sprayed on AZ91D magnesium alloy
?以Ni-Al為粘結層，在AZ91D鎂合金基體上等離子噴涂Ni-Al/Al2O3、Ni-Al/Al2O3-13%TiO2?(Ni-Al/AT13)、Ni-Al/Al2O3-20%TiO2(Ni-Al/AT20)復合涂層及Ni-Al/Al2O3/Al2O3-13%TiO2/Al2O3-20%TiO2?(Ni-Al/Al2O3/AT13/AT20) 梯度涂層，利用SEM、EDS和XRD分析涂層的微觀組織特征，通過硬度、拉伸和熱震實驗研究涂層硬度、結合強度和抗熱震性能，并與直接噴涂Al2O3、AT20的涂層進行比較。結果表明：Ni-Al粘結層因“自粘結”效應與基體形成較為致密并具有冶金結合的界面，且與Al2O3、AT13和AT20陶瓷層互有滲透、交叉和嚙合，涂層致密性及結合力大為提高，表現出優良的抗熱震性能。Al2O3涂層主要由亞穩態γ-Al2O3組成，AT20涂層以Al2O3和Al2TiO5為主。鎂合金表面噴涂Al2O3陶瓷層后硬度大幅提高，由于加入TiO2，AT13和AT20涂層的硬度略低于Al2O3涂層的。Ni-Al/Al2O3-TiO2復合陶瓷的涂層結合強度高于Ni-Al/Al2O3單一陶瓷涂層的，而Ni-Al/ Al2O3/AT13/AT20梯度涂層的結合強度比Ni-Al/AT20涂層的更高。
By means of plasma spraying, Ni-Al/Al2O3, Ni-Al/Al2O3-13%TiO2?(Ni-Al/AT13) and Ni-Al/Al2O3-20%TiO2(Ni-Al/AT20) composite coatings as well as Ni-Al/Al2O3/Al2O3-13%TiO2/Al2O3-20% TiO2?(Ni-Al/Al2O3/AT13/AT20) gradient coating were fabricated on the AZ91D magnesium alloy with Ni-Al as the base coating. The microstructure characteristics of the coatings were investigated by scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDS) and X-ray diffractometry (XRD). The hardness, bonding strength and thermal shock properties of the coatings were evaluated by microhardness, tensile and thermal shock tests. The coatings with Ni-Al as the base coating were compared with Al2O3?and AT20 coatings without Ni-Al. The results show that denser interface with metallurgical bonding forms between Ni-Al and AZ91D substrate due to Ni-Al base coating’s self adhesive effect. Ni-Al coating can interpenetrate into, cross and gear with Al2O3, AT13 and AT20 coatings, thus remarkably improving the compactness, bonding strength and resistance to thermal shock. Al2O3?coating is mainly composed of metastable γ-Al2O3?while AT20 coating mainly consists of Al2O3?and Al2TiO5. After plasma sprayed with Al2O3?coating, the surface hardness of AZ91D alloy increases evidently. The hardness of AT13 as well as AT20 coatings is slightly lower than that of Al2O3?coating because of the addition of TiO2. The bonding strength of Ni-Al/Al2O3-TiO2?composite ceramic coating is higher than that of Ni-Al/Al2O3?single ceramic coating and Ni-Al/Al2O3/AT13/AT20 gradient coating shows high bonding strength than Ni-Al/AT20 coating.
以上資料由上海艾荔艾金屬材料有限公司提供，歡迎新老客戶來電洽購。
本文來自上海艾荔艾金屬材料有限公司http://www.85978597.cn，轉載請注明出處。
前一頁：2195合金鍛造管的淬火與時效工藝
后一頁：T6時效和T6I6時效對6005A鋁合金微觀組織和性能的影響