新聞資訊
初生α相含量對TC4 ELI鈦合金動態應力?應變行為的影響
發布人：上海艾荔艾金屬材料有限公司www.85978597.cn
更新時間：2015-10-22
利用分離式霍普金森壓桿(SHPB)裝置，對低間隙Ti-6Al-4V(TC4 ELI)鈦合金中4種初生α相含量不同的等軸組織在不同應變速率(2 000、3 000和4 000 s?1)下進行動態壓縮試驗，通過動態壓縮試驗得到材料的動態真應力-應變(σ-ε)曲線，并利用金相顯微鏡(OM)等對試驗后發生剪切失效破壞試樣的端面進行觀察分析。
初生α相含量對TC4 ELI鈦合金動態應力?應變行為的影響Effect of primary α phase content on dynamic stress?strain behavior of TC4 ELI titanium alloy
利用分離式霍普金森壓桿(SHPB)裝置，對低間隙Ti-6Al-4V(TC4 ELI)鈦合金中4種初生α相含量不同的等軸組織在不同應變速率(2 000、3 000和4 000 s?1)下進行動態壓縮試驗，通過動態壓縮試驗得到材料的動態真應力-應變(σ-ε)曲線，并利用金相顯微鏡(OM)等對試驗后發生剪切失效破壞試樣的端面進行觀察分析。結果表明：隨著初生α相含量的增加，TC4 ELI的平均動態流變應力、均勻動態塑性應變和沖擊吸收功(E)的變化規律不明顯，在4 000 s?1應變速率加載條件下，4組試樣均發生剪切失效破壞，在失效試樣的端面觀察到幾乎呈同心的圓弧形白亮絕熱剪切帶(ASB)，部分剪切帶發生分叉，裂紋在剪切帶內形核、長大和聚合，最終導致試樣斷裂。
The dynamic mechanical properties of four equiaxed microstructures with different contents of primary α phase in Ti-6Al-4V extra low interstitial (TC4 ELI) were studied with split Hopkinson pressure bar device. The dynamic stress-strain curves under different conditions were obtained, and the end surfaces of samples lapsed by shear force were examined under a optical microscope. The results show that there exists no regularity on the variation of dynamic strength, dynamic strain and absorbed energy of TC4 ELI alloy with the increasing content of primary α phase. The shear failure damage occurs at the strain rate of 4 000 s?1, the white light adiabatic shear bands (ASBs) of almost concentric are-shaped are observed on the specimen face of four samples. The bifurcation of some adiabatic shear bands occurs. The cracks nucleate, grow and converge in the ASBs, eventually leading to specimen fracture.
以上資料由上海艾荔艾金屬材料有限公司提供，歡迎新老客戶來電洽購。
本文來自上海艾荔艾金屬材料有限公司http://www.85978597.cn，轉載請注明出處。